LEWIS GARAGE DOORS
607-324-0271
WOOD FLUSH DOORS
Flush wood doors provide an economical choice, while offering the most flexibility in design and size options. Three different exterior grade options are available. Options include glazed sections and hardware upgrades to accommodate aftermarket facing applications
Features
F2S-Smooth
- 1-3/8" Thick
- 1/8" Hardboard both sides
- Polystyrene core bonded to
both skins
- R-Value of 7.1
- Ship Lap sections
- Three struts supplied on all doors
Any warranty against bowing or warping will be void unless painting & handling instructions are strictly adhered to. If doors are to be painted a dark color with high exposure to direct sunlight, extra struts are required. These doors are not warranted against swelling along the edges.
F2S-Plywood
- 1-1/2" Thick
- 1/4" Lauan Plywood both sides
- Polystyrene core bonded to
both skins
- R-Value of 7.1
- Ship Lap sections
- Three struts supplied on all doors
Doors over 10' wide have a seam down the center of the outside skin. Please avoid these sizes.
F2S-RX Plywood
- 1-5/8" Thick
- 3/8" Roughsawn Plywood exterior skin
- 1/4" Lauan Plywood interior skin
- Polystyrene core bonded to
both skins
- R-Value of 7.1
- Ship Lap sections
- Three struts supplied on all doors
This product is manufactured with Breckenridge Siding plywood with an imported face veneer of Acuma that is generally clear, but not free of imperfections. There may be minor splits, small knots & burls, and color variations in the plywood. These are acceptable and not to be considered defects.
Painting
All wood flush doors are available "factory primed". The end user is required to apply two layers of top coat using a quality LATEX EXTERIOR paint ON BOTH SIDES and ALL EDGES. Since primers are not designed to be exposed to the weather, top coats are required for complete protection. General Doors Corporation highly recommends the top coat be applied prior to installation to achieve maximum protection. Excessive exposure of the primer coat to moisture will compromise the finishing system and VOID the warranty.
NOTE: Door sections MUST be finished within 10 days of delivery and PRIOR to installation using the finishing guidelines above for warranty to remain in effect. Paint grade doors cannot be stained.
General Doors Corporation warrants that its door sections are manufactured to meet or exceed industry standards at time of shipment. Failure to follow the recommended finishing instructions above may lead to premature failure and VOID the factory warranty.
HANDLING INSTRUCTIONS
Storage and Handling
- Door sections should always be stored on flat, carefully leveled supports, and kept in a clean, dry, and well ventilated building.
- Do not deliver door sections to a job site until concrete floors and painted walls are thoroughly dry.
- Door sections should never be exposed to excessive moisture, heat, dryness, or direct sunlight
Finishing
Door sections must be resting flat on leveled supports using one pair of 2x4's running underneath each section lengthwise.
DO NOT REST DOOR SECTIONS ACROSS SAW HORSES WITHOUT SUPPORT RUNNING THE FULL LENGTH OF THE SECTIONS OR BOWING MAY RESUL